| |
|
8", Replacement Chain For B &D 18V Cordless Chain Saw, Model# CCS818, True Value #823-185.
|
«
chain
»
This chain was for my Black & Decker battery run chain saw. I could not
find the chain any where but Amazon. It was delivered very fast and
is a good buy. Don't hesitate to buy it.
Rating: 
(5
out of 5) @ 2008-11-16
|
«
Good Spare Chain
»
Nice product. Will come in handy in the case that you dull your original chain.
Rating:
(5
out of 5) @ 2008-09-30
|
«
Black & Decker #RC800 8" Cordless Saw Replacement Chain
»
Using this on my 18volt cordless chain saw, it's a low kick back saw, and cordless chain saw are low rpm to begin with, so I guess that " MADE IN CHINA" part doesn't bother me, keep it well lube, before during and after each use, put ptfe dri-film on it befor putting on new sets, for around the house maintance, not a professional saw for sure. And remember to clean it up, it do get stuck easily when batteries are low.
Rating:
(5
out of 5) @ 2008-08-08
|
«
Handy Little Chain Saw
»
The Black & Decker CCS818 18 volt battery powered chain saw is extremely handy. Granted it will not replace my gas powered chain saw, but I find it is very useful in places/situations where I cannot effectively use the gas powered saw. The major use I find for this product is cutting small (3" or less) branches into stove length pieces. It is great in this application. It is small and light enough that I can hold it in one hand, the branch in the other and saw. The chain that comes with the saw has remained sharp, but I know it will eventually become dull.
I have used the saw and current chain for about 6 months now; cutting Manzanita, Madrone, Oak, Cedar and some pine without any problems. The largest diameter trunk that I've cut with the saw was a 7" diameter pine that had died last summer. (Even though the saw and chain completed the job, I don't think I'll try that again).
I will be buying a replacement chain, so if the current chain becomes dull in the middle of a cutting session, it can be replaced and the job continued, then the dull chain sharpened that night. The only problem I have had so far, is finding a spare chain to have available when needed.
Rating:
(5
out of 5) @ 2008-05-21
|
«
Not very powerful
»
I've had the opportunity to use this chainsaw once and was not very impressed with its power or cutting speed. It's a neat looking little tool, and is probably sufficient for most lightweight cutting jobs; but don't expect it to take the place of a gas-powered saw. In itself, it is very lightweight and easy to weld, but branches much over 5 inches would not be an easy cut for this tool.
Rating: 
(2
out of 5) @ 2008-02-08
|